VisbreakerFoamControl

Visbreaker Foam Control

Foaming occurs in the visbreaker distillation fractionator column or vacuum flasher column, potentially resulting in the degradation of side cut quality. Foaming can result in black gas oil that may need to be either rectified or downgraded. Control of this foam allows for the distillation columns to maintain capacity and specification.
  1. Home
  2. Our Offerings
  3. Visbreaker Foam Control

Contact Us

GIVE US A CALL

Ecolab
2 Drake Avenue
MacQuarie Park NSW
Australia 2113

Contact your Ecolab Representative today, or call/email Ecolab Customer Service.

Tel: 1800 022 002 | Fax: 1800 655 679 | Email: ausecolink@ecolab.com

To request additional information about Nalco Champion Refining Treatment products and services just complete the form below and a Nalco Champion representative will contact you. To inquire about career opportunities please refer to the careers section.

Contact
Max. 255 characters

In a visbreaker unit, it is necessary to quench the furnace or soaker effluent temperatures to minimise both further thermal cracking reactions and coke deposition in the fractionator flash zone and residue stripping trays. Usually a distillate quench is used, which is recycled over the fractionation section, increasing the flash zone liquid load and promoting foaming. In the vacuum flasher, the liquid load is higher by nature, potentially due to recycle, increasing the potential for foaming.

In either of these areas of the process, foaming results in the degradation of distillation efficiency and may result in black gas oil cuts, which are very costly.

To minimise these impacts, Nalco Champion has developed antifoam agents that are stable, so the antifoam stays in the fractionator residue and is not entrained in lighter streams. Our antifoam programs reduce costly impacts of foam on throughput and side stream quality.